Before starting studying assembly procedure we recommend to look at your greenhouse diagram where you find description of all items from the assembly instructions.
A | Gable Base Frame | H | Front and Back Gable Stalks |
B | Side Base Frame | J | Gable Lintel |
C | Bottom Corner Section | K | Roof Beam |
D | Roof Corner Section | L | Midfeather |
E | Wall Beam | M | Brackets |
F | Ridge Capping | T | Bracing Ridge Tile |
G | Binding Bar |
---|
|
The basic construction element of the greenhouse is a „ hockey stick“ created by joining the roof beam K with the wall beam E using a bracket M.
|
|
The very important step is the correct assembly of the base frames B that are to be bolted so that to let the central hole free.
|
|
On mounting the front gable join the bottom corner section C (left) with the roof corner section D (right) to create a „gable hockey stick“. The roof element must go over.
|
|
Bolt the left and right „gable hockey stick“ to the gable lintel G. The whole assembly complete by fixing a small gable to the „hockey stick“ ends.
|
|
Bolt both front gable stalks - one of them has 4 holes for door hinges, the other the 10mm hole for door catch - to the gable „hockey sticks“.
|
|
Fastening midfeathers to the door stalk. The whole greenhouse (two face walls) has 6 left and 6 right partitions that differ both in lenght and bevel.
|
|
Fasten the whole front gable frame to the base frame with bolts M6x30. Join only part A with door stalks H, not the frame A with bottom corner section C.
|
|
Place the assembled front gable frame on the greenhouse base and join with the side base frame B - then bolt the frame with the bottom corner section C.
|
|
Back gable assembly procedure is the same as the front one - but instead of the door use three horizontal equal lenght partitions.
|
|
Before completing the roof assembly fasten hingers for the vent to the ridge capping F.
|
|
Using the bolts M6x30 join the front gable with the upper ringe capping F and bottom bracing ringe tile T.
|
|
„Side „hockey sticks“ assembly - bolt the longer arms to the base frame, push them between the bracing ringe T and upper ringe F on top and bolt together.
|
|
Joining the binding bar G to the front gable frame - the wider part of the bar is always oriented down.
|
|
Screw the vent to the two hingers on the upper ringe.
|
|
Perform glass-glazing.
|
|
Fasten the glass panes in place with special simple or double clips.
|